Arietta ALS436SS Instruction Manual download pdf (Page 7)

■ Remove the knockout and the Junction box cover and install

the conduit connector (cULus listed) in junction box.

■ If not already done, install

⁄2” conduit connector in j-box.

NOTE: This connector is not included with vent hood.

■ Run black (live), white (neutral), and green (earth) wires (#14 AWG)

according to the National Electrical Code or CSA Standards and local

codes and ordinances in

⁄2” conduit from power supply to j-box.

■ Connect black, white, and green wires from power supply to black,

white, and green/yellow wires in j-box respectively.

■ These connections should be done while always making reference to

the electrical diagram found inside the hood.

■ Close j-box cover and reapply.

If range hood does not operate:

■ Check that the circuit breaker is not tripped or the house fuse blown.

■ Disconnect power supply.

■ Check that wiring is correct.

Keep your Installation Instructions and Use and Care Guide close to

range hood for easy reference.

Mounting the duct cover

■ Position the duct cover over the mounted hood.

■ Slide the bottom of the duct into the glass area.

■ Position the top of the duct over the duct mounting bracket. If a

telescopic duct cover is used, grab the upper part of the

telescopic duct cover, pull it and place it in the duct cover

mounting bracket.

■ Secure the top of the duct with 2 assembly screws provided.

■ Secure the bottom of the duct with 2 assembly screws provided.

■ Install the grease lter and turn power on at service panel.

■ Check operation of the hood.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Arietta ALS436SS Instruction Manual Page 7