Arietta ALS436SS Instruction Manual download pdf (Page 10)

Replacing the halogen lamp

CAUTION: Before replacing the lamps, disconnect power off

to prevent from being switched on accidentally.

Turn off the range hood and allow the halogen / incandescent

lamp to cool. To avoid damage or decreasing the life of the new

bulb, do not touch bulb with bare ngers. Replace bulb, using

tissue or wearing cotton gloves to handle bulb.

If new lamps do not operate, make sure the lamps are inserted

correctly before calling service.

■ Disconnect power.

■ Use a at-blade screwdriver and gently pry the light cover

loose.

■ Remove the lamp and replace with a 120-volt, 40-watt

maximum, halogen lamp made for a G-9 base.

■ Replace the light cover.

■ Reconnect power.

Cleaning

■ Always use the mildest cleaner that will do the job. Use clean,

soft cloths, sponges or paper towels.

■ Rub stainless steel nishes in the direction of the grain. Wipe

area dry to avoid water marks.

■ After cleaning, place all parts in their proper positons before

using.

■ The cleaners recommended below indicate a type and do not

constitute an endorsement. Use all products according to

package directions.

Hood Surface

Stainless Steel Surfaces: Wipe and dry stainless steel in the same

direction as the grain. Avoid using too much pressure, which may

mar the surface. To remove nger prints and give added shine,

use cleaners such as Stainless Steel Magic. Do not allow any

cleaning compounds to remain in contact with stainless steel for

extended periods.

Plastic Surfaces: Wipe with a moist soapy sponge. Rinse and dry.

Aluminum Mesh Filters: Clean lters in the dishwasher or by

agitating in sudsy water. Ensure that there is no soil trapped in the

ne mesh. Dry the lters before reinstalling them.

Optional Recirculating Kit

■ If the model is not vented to the outside, the air will be

recirculated through disposable charcoal lters that help

remove smoke and odors.

■ The charcoal lters cannot be cleaned.

■ They must be replaced.

■ The charcoal lters are clipped inside of each metal grease

lter (mounting instructions included with recirculating kit mod.

KIT01937).

■ The charcoal lters should be replaced every 4-6 months

(depending on hood usage).

NOTE: DO NOT rinse, or put charcoal lters in an automatic

dishwasher.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Arietta ALS436SS Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Cooker hoods Arietta ALS436SS