10BCDAA.Screws-3.5x9.5mmflat-head(4)B.Faceplate(30”x12”[76.2cmx30.5cm]shown)C.Cabinet(30”x12”[76.2cmx30.5cm]shown)D.Scre
12Replacing the halogen lamp (ARG628SS models) CAUTION: Before replacing the lamps, disconnect power off to prevent from being switched on accidentall
13WARRANTYELICA North America TWO-YEAR LIMITED WARRANTYTO OBTAIN SERVICE UNDER WARRANTYOwnermustpresentproofoforiginalpurchasedate.Pleaseke
3WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Use this unit only in the manner intended by the
4Tools and PartsGather the required tools and parts before starting installation.Read and follow the instructions provided with any tools listedhere.T
5Installation Clearances A.12”(30.5cm)min.upper cabinet heightB.30”(76.2cm) cabinet opening width*C.24”(61cm)min.36”(91.4cm)suggested
6Venting MethodsThis range hood is factory set for venting through the roof orthrough the wall. You can apply the recirculating venting method by purc
7Installation InstructionsPrepare Location It is recommended that the vent system be installed before the range hood is installed. Before making c
8Venting Outside Through the RoofMeasure and mark the lines as shown. Use a saber saw orkeyhole saw to cut an opening through the top of the cabinetan
9Complete Preparation3. Ifnotyetattached,installthe6”(15.2cm)venttransitionthetop of the range hood liner using two 3.5 x 9.5 mm screws.4.
Comments to this Manuals