Arietta AGR628SS Instruction Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 13
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
9
Complete Preparation
3. Ifnotyetattached,installthe6”(15.2cm)venttransitionthe
top of the range hood liner using two 3.5 x 9.5 mm screws.
4. Locatesidemountingbracketush1cmtothebottomofthe
cabinet side and against the inside of the front cabinet face.
Orient the bracket depending on the width of your cabinet as
depictedinthediagramsbelow.Drill⅛”(3mm)pilotholesin
6 places, attach a bracket using three 4.5 x 13 mm screws to
each side of the cabinet, and tighten. Additional washers in
hardware package are supplied as spacers for cabinet walls
thinnerthan½”(13mm).
BracketOrientationfor30”(76.2cm)Cabinet
A
B
C
D
A.30”(76.2cm)cabinet
B.Screws-4.5x13mm(6)
C.Washers(optional)
D.Mountingbracket(2)(positionfor30”[76.2cm]cabinet)
Move the bracket
6
16”(1cm)fromthebottom
side of the cabinet
5. Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Using 2 or more people, lift the hood liner into its mounted
location. Attach with four 4.2 x 19 mm screws into the slotted
openings. Do not tighten screws.
A
B
C
A.Cabinet
B.Hood liner canopy assembly
C.Screws-4.2x19mm(8)
2. Center the canopy in the cabinet. Align the bottom of the
canopy with the bottom of the cabinet. Install four 4.2 x 19 mm
screws into the round mounting plate openings and tighten all
(8)mountingscrews.
3. Removethemetalgreaseltersfromthefacepanel.Seethe
“Range Hood Care” section.
4. Attach the face plate to the hood insert.
NOTE: If cabinet depth is greater than 12”, it is recommended
that the two 1/2” metal spacers are installed.
Install to front and rear sides of the face plate with 3.5 x 9.5
mm screws as shown in drawing.
C
A
C
B
A.Face Panel
B.Front and rear spacer
C.Screws-3.5x9.5mm(4)
Seeinstructionbelowforyourspeciccabinetsize.
Install Range Hood
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments