Arietta PRO001MX30 Instruction Manual download pdf (Page 15)

Installation Instructions

Wall Mount Installation

WARNING - The following instructions are intended for drywall only, please note that when installing to concrete/masonry

additionalwallfasteneranchors(notprovided)shallbeused

Note:seebelowifcabinetinstallationispreferred

4.Afterthehoodinstallationheighthasbeendetermineddrawahorizontallineatadistanceabovethecooktopequaltothe

desiredhoodinstallationheightplus10”.

5.Findthecenterlineofthecooktop.Drawaverticallinealongthiscenterlineuptothehorizontallinedrawninstep1and

drawaverticallinerightandleftatadistanceof11-59/64"(for36"model)or8-15/16”(for30"model)todeterminethe

mounting location of the mounting hooks shipped with the hood.

6. Fit two mounting hooks on the wall to hang the hood through the provided slots

(2hooks+2screws5x35).

7.Run8”Duct,longenoughtoreachthetransitiononcethehoodhasbeeninstalledplus

11/2”inchtoconnectductwork.FixDucttotransitionwithscrewsandsealwithtape.

8.Remove1of2knockoutsandinstall1/2”conduitconnectorinj-box.

9. Hang the hood and adjust its position through the screws on the hooks.

10.Fixthehoodto4additionalpoint,2onupperside,2onlowerside(use4washers+4screws5x35.

Cabinet Installation:

4. Find the centerline of the cabinet bottom. Draw a line along this centerline from rear to front of the cabinet.

5.Drawtwolines,oneataKdistancefromthewall,theotheroneataZdistancefromthepreviousline.

Mark 4 points , two along each line at a distance of half W from the center line, to determine the screw locations.

6.Fit4screwsoncabinetbottomdonottightencompletelybutleaveaspaceofabout1/2”fromcabinetbottomsurface

and head screws.

7.Run8”Duct,longenoughtoreachthetransitiononcethehoodhasbeeninstalledplus11/2”inchforconnectductwork.

8.Remove1of2knockoutsandinstall1/2”conduitconnectorinj-box.

9. Hang the hood on screws through side slots provided on hood top.

Tighten the four screws.

Note:Ifpossiblexthehoodonthewallat4additionalpoint(2onupperside,2onlowerside).

10.From the inside of the cabinet attach the transition on upper outlet.

FixDucttotransitionandsealwithtape.

11 59/64“11 59/64“

10“

7/16“

/16“

8 1/4“

18 “

8 15/16“8 15/16“

10“

7/16“

/16“

8 1/4“

18 “

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 46 47

No comments

Arietta PRO001MX30 Instruction Manual Page 15