Arietta PRO001MX30 Instruction Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 47
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
Installation Instructions
Discharge Direction:
WARNING!
Before installing remove the knock-out plate that close the air outlet on the top if is
desiredtousetherangehoodforverticaldischargeORtherearoutletifisdesiredto
usetherangehoodforhorizontaldischarge.(seealsoFigurebelow).
WARNING!
ONCE THE KNOCK OUT PLATE HAS BEEN REMOVED, THIS CANNOT BE REINSTALLED ANYMORE
TO CLOSE THE AIR OUTLET
Tochangetohorizontaldischarge,dothefollowing(seealsoFigurebelow):
a.Removeknock-outplateontherearsideofthehood(seealsoFigurebelow)
b.Removeandkeepthe4screws(2perside)thatxblowerontopofthehoodandrelease
it from keyholes.
c.Rotatetheblower90°andcheckthatpinsonsideblowerxingbracketstintothepreinstallingholes.
d.Fixtheblowerontherearsidewiththesame4screws(seestepb).
3. Assembly of the 8” Transition:
The transition supplied with the hood mounts to the top or rear of the hood.
Note-CabinetinstallationwithverticaldischargeONLY:donotinstalltransitionuntilhoodhasbeenxedon
cabinet.
a. Place the transition piece over the hood
exhaustandsecurewith4screwsprovided(Figurebelow).
b. Duct tape connection between transition and hood.
VER T I C AL D I S CHAR G E
HORI ZON TAL D I SCHA R G E
Pin
Keyhole
Pin
Top screw location
Square slot
Bottom fixing screw location
Knockouts (junction box)
Vertical discharge Knockouts
Vertical discharge Knockouts
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 46 47

Comments to this Manuals

No comments