Arietta CHN001MX36 Instruction Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 53
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
Product Dimensions and Clearances
DuctCoverBracket
16-26/32”
29-5/16”
30” Gas Cooktop
24”-30“ Electric Cooktop
h
h
20”
30“
36“
The vent hood must be installed above the cooking surface at 30" (minimum) if a gas range is used or from 24"
(minimum) to 30" if an electric range is used.
If the customer needs that the duct cover reaches from 8' to 10' ceilings height, then an additional telescopic duct
cover accessory is needed.
The hood may be installed onto a wall and vented to the outdoors, or it can be installed for recirculating operation
(recirculating accessories not supplied with the hood).
This hood must not be installed over any professional cooktop / range.
Installing preparation
Advance planning
Determine the exact location of the vent hood.
Plan the route for venting exhaust to the outdoors.
Use the shortest and straightest duct route possible. For satisfactory performance duct run should not exceed
100’ equivalent length for any duct configurations.
Refer to “Duct Fittings” chart to compute the maximum permissible length for duct runs to the outdoors.
Install a wall cap with damper or roof cap at the exterior opening. Order the wall or roof cap and any transition
needed in advance.
Use 6" round metal ductwork only.
Wall framing for adequate support
This vent hood is heavy. Adequate structure and support must be provided in all types of installations.
If mounting on dry wall, the hood must be secure to vertical studs in the wall, or to a horizontal support.
The vent hood should be on site before final framing and wall finishing. This will help to accurately locate the
duct work and electrical service.
Installation will be easier if the vent hood is installed before the cook-top and countertop are installed.
Removing the packaging
CAUTION: Remove tthe carton carefully. Wear gloves to protect against sharp edges.
WARNING: Remove the protective film covering the product before putting into operation.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 52 53

Comments to this Manuals

No comments