Arietta KIT01940 Instruction Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 7
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
Figure 2.
Air passage cut-out on hood
Hood Preparation
The hood transition must not be installed, since no ductwork is necessary, if it is installed, remove
the transitions.
Attach two pins B on top of the hood. See Figure 2. Make sure a Gap exists between the hood and
the hood surface.
Wall Mount Installation
First install the deflector on top of the hood, then install to the wall:
1) Attach four screws C on bottom of the deflector, do not tight completely, and leave approximately ¼”
from the bottom of the air deflector to the screw head. See Figure 2.
2) Install the deflector on top of the hood so that screws C and pins B go respectively into the existing side
slots at the top of the hood and the existing side slots at the bottom of the deflector (See Figure 2), slide
deflector frontward until it mechanically stops.
3) Tighten the four screws C from the inside of the hood.
4) Attach screws D from inside the hood through points E to attach the air deflector to the hood (see
Figure 2, number depends on hood size).
5) Proceed to install hood as described on the hood manual.
Installation under Cabinet
First install the deflector under the cabinet, and then install Hood to the air deflector:
1) Find the centerline at the bottom of the cabinet. Draw a line along this centerline from rear to the front of
the cabinet.
2) Draw two lines, one at a 1-1/2” of distance from the wall, then other at a 9-1/16“ distance from the
previous line. Identify and mark 4 points for the screw locations, divide by two the distance W, and
measure the obtained distance from the center line to the left and right sides, mark the points (see
Figure 3).
3) Attach 4 screws at the bottom of the cabinet (screws not supplied) do not tight completely; leave a
space of 1/2” from cabinet bottom surface and screw heads. Note: the screws must be able to support
the hood and deflector weight, and must be the right type according with the bottom cabinet surface.
4) Hang the deflector at the screws through the side slots present in the deflector top. Tight the four
screws through slots F. See Figure 2.
5) Attach four screws C at the bottom of the deflector, do not tight completely. See Figure 2.
6) Install the hood at the bottom of the air deflector so that screws C and pins B go respectively into the
existing side slots at the top of the hood and the existing side slots at the bottom of the air deflector
(See Figure 2), slide the hood rearward until it stops.
7) Remove 1 of 2 knockouts and install 1/2“conduit connector in j-box.
8) Attach screws, from inside of the hood through point E to final assembly Deflector to the hood (see
Figure 2, number depends on hood size).
3
Page view 2
1 2 3 4 5 6 7

Comments to this Manuals

No comments