Arietta KIT01940 Instruction Manual download pdf (Page 2)

WARNING:

• Read and Save These Instructions.

• Approved for Residential Appliances only.

• PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.

• INSTALLER: Please leave these Instructions with this unit for the owner.

• OWNER: Please retain these instructions for future reference.

• Turn off power circuit at service panel and lock out panel before installing this kit to the appliance.

• Installation must comply with all local codes.

PACKAGING CONTENTS

• Air deflector

• 3 Charcoal Filters

• 12 springs

• Mounting hardware

BEFORE INSTALLING THE RECIRCULATING KIT

The recirculation kit installation affects the hood installation, so take in consideration the following steps.

Cabinet or ceiling preparation when installing the recirculation kit

For cabinet or ceiling preparation take in consideration that there is no need to provide cutouts on walls for

vertical or rear air discharge, since there is no need to install any duct work. See the figure 1 for conduit

passage cut-out. See figure 2 for air passage cut-out on hood.

Cabinet

front

3-1/8” x 2-1/3”

Cut out for

conduit

passage

Bottom of

cabinet or

soffit

12” min

27/32”

Real

wall

Center

line

Hood width min.

Figure 1. Conduit Passage Cutout

Note: The height of the hood with the recirculation kit installed, increases from 18" to 22“. Check that

there is enough clearance and that minimum height from the countertop to the bottom of the hood is

24” minimum for electric ranges to 30” minimum for gas ranges.

1 2 3 4 5 6 7

No comments

Arietta KIT01940 Instruction Manual Page 2